GREPhysics.NET
GR | # Login | Register
   
  GR0177 #91
Problem
GREPhysics.NET Official Solution    Alternate Solutions
This problem is still being typed.
Mechanics}Conservation of Energy

Conservation of energy gives  Mg(H) = \frac{1}{2}Mv^2 + \frac{1}{2}I \omega^2. v=R\omega, and thus the equation becomes

 Mg(H) = \frac{1}{2}Mv^2 + \frac{1}{2}I (v/R)^2.

Thus, I=2(MgH-\frac{1}{2}Mv^2)R^2/v^2. (Note that the height of the center of mass is the same at both the end and the start, thus the extra bit of the potential energy MgR cancels out. Thanks to the user keflavich for this correction.)

Given v^2 = 8gH/7, one plugs it into the equation above to get

I=2(MgH  -M4gH/7)R^2/(8gH/7)=2(3MgH/7)R^2/(8gH/7)=3MR^2/4, as in choice (B).

See below for user comments and alternate solutions! See below for user comments and alternate solutions!
Alternate Solutions
Ning Bao
2008-02-01 08:11:02
Let R, m,h,g=1. Then you just have

1=1/2*8/7+1/2*I*8/7
1=4/7+4/7*I
I=3/4.
Alternate Solution - Unverified
Comments
redmomatt
2011-10-08 15:23:01
Did this by process of elimination (not even looking at the PE versus KE).

(A) can't be true, since the cylinder is not of uniform density.

(D) can't be true, since this would only occur if all of the mass were concentrated in a thin ring at a distance R.

(E) can't be true, since the largest moment would be (D).

We are left with (B) and (C). Because a radial mass distribution that varies as \rho R should be less than something very close to (D), we are left with choice (B).
Nezumi
2012-02-09 18:27:24
The radial dependence is not given to be linear. I Think (B) or (C) remain until you look at energy.
Nezumi
2012-03-06 12:06:24
I was looking at the problem again. The elimination you did is the right place to start. Once you have it down to (B) and (C), look at the translational energy.
T = \frac{1}{2}Mv^2
= \frac{1}{2}MgH\frac{8}{7}
\g \frac{1}{2}MgH

since the translation takes up a little more than half of the original energy of the object, less than half is available for the rotational energy. This implies a smaller moment of inertia, hence choice (B)
NEC
Ning Bao
2008-02-01 08:11:02
Let R, m,h,g=1. Then you just have

1=1/2*8/7+1/2*I*8/7
1=4/7+4/7*I
I=3/4.
smokwzbroiplytowej
2008-10-21 11:27:20
Nice - sure helps save time! Caveat: you really can't set R=1 and h=1 simultaneously, since they are both measures of length.

Here it works rather nicely, because H cancels out as you could tell from the answers.
Alternate Solution - Unverified
neutrino
2007-10-31 03:28:11
You can make the calculation more easy by noting that the rotational inertia will look like

I = \alpha M R^2  ,

with \alpha some constant. Now, you just have to solve:

MgH =  \frac{1}{2} M v^2 (1 + \alpha)

This might save you some time. Because, 1.7 min..., man, that is not much time.
tommy22222
2019-10-22 14:57:59
BRILLIANT!!! I think this is the best and the most make sense alternative solution under this pose.
NEC
Richard
2007-10-30 18:38:31
A potentially useless note:

The solution given in (E) is found by NOT accounting for the translational kinetic energy.
NEC
Andresito
2006-03-05 00:00:42
Yosun, there is a typo on your solution. When you express I, the term MV^2 has a factor of 2 implicitly.

Recall the conservation of energy equation, multiply both terms by 2 and the "only" term that has now a factor of 2 is MgH.

The correct expression should have I=(2 MgH - MV^2) (r/v)^2

Yosun, thank you very much for working out the problems. If you are a girl I send you a big kiss :). I obtained the pdf from the yahoo-group. It also has the typo.
Typo Alert!
keflavich
2005-11-10 22:48:10
You don't need to consider MgR as part of the gravitational potential energy. When the cylinder reaches the bottom of the plane, its center of mass will remain at a distance R above the ground.
yosun
2005-11-10 22:54:19
keflavich: you're right that the center of mass stays at a height of R above the ground at both points. thanks for the correction.
Fixed Typos!

Post A Comment!
You are replying to:
A potentially useless note: The solution given in (E) is found by NOT accounting for the translational kinetic energy.

Username:
Password:
Click here to register.
This comment is best classified as a: (mouseover)
 
Mouseover the respective type above for an explanation of each type.

Bare Basic LaTeX Rosetta Stone

LaTeX syntax supported through dollar sign wrappers $, ex., $\alpha^2_0$ produces .
type this... to get...
$\int_0^\infty$
$\partial$
$\Rightarrow$
$\ddot{x},\dot{x}$
$\sqrt{z}$
$\langle my \rangle$
$\left( abacadabra \right)_{me}$
$\vec{E}$
$\frac{a}{b}$
 
The Sidebar Chatbox...
Scroll to see it, or resize your browser to ignore it...